The machine is equipped with a positive pressure nozzle, which effectively isolates dust and waterproofs.【detailed】

The recommended distance between the nozzle and the product surface is between 5MM and 15MM. If the distance is too low, it is likely to cause severe ink accumulation on the high-pressure plate of the nozzle, affecting the printing effect; if the distance is too large, the character spacing of the ink printing effect will be large, and the overall ink printing content is prone to deformation.【detailed】

Only in the printing state can the 4 quick setting functions in this area be used. After parameter setting, click the "Start" printing button first, stop the printing, and then click "Start" printing again. The current printed content is the debugging effect after the current quick setting.【detailed】

Firstly, the distance between the sensor and the nozzle should be as close as possible, so that it is easier to obtain the starting printing position of the product; secondly, the fixed direction of the nozzle should form a 90-degree angle with the production line equipment to ensure that the printed content does not skew; if the product is side-printed, the nozzle should be installed on the side, and it should form a 5°-10° angle from top to bottom to avoid ink leakage and backflow from the nozzle, which may cause other unnecessary faults.【detailed】

The ink printer should avoid being operated next to equipment with high power to prevent interference with the motherboard electrical signals and affect the printing effect; the ink printer needs a grounding wire to avoid interference from static electricity from large equipment.【detailed】

The ink printer has a dual-file printing function. When the text to be printed is too long, it can be set as two files separately, and then print simultaneously.【detailed】

If the ink printer is planned to be out of use for 30 days, it is recommended to start the machine and supply ink for 1 to 2 hours within 7 days after the interval; if it is planned to be out of use for 2 to 6 months, the ink in the machine should be drained, and the entire ink path system should be cleaned using a dedicated cleaning agent; at the same time, keep the last cleaning agent in the machine and start the machine to run for 2 hours every month.【detailed】

The nozzle plate is blocked, causing the ink line to shift, resulting in the phenomenon of ink flying. It is recommended to check and use the dedicated cleaning agent before or after starting the machine to clean the nozzle.【detailed】

There is a slight ink accumulation on the nozzle, causing the ink line position to shift, resulting in the phenomenon of ink flying. The solution: Clean the nozzle of ink; during daily use, it is necessary to develop the habit of checking the cleanliness of the nozzle.【detailed】